Safety and installation warnings


Environment
Ambient temperature
Make sure the ambient temperature does not exceed the maximum ambient temperature allowed for the ExaLINK Fusion (104F, 40C). If installed in a closed or multi-unit rack assembly, the ambient temperature of the rack during operation will be greater than room ambient.

Air flow
Install the ExaLINK Fusion in the rack in a way that provides sufficient air flow for safe operation.

Mechanical loading
Mount the ExaLINK Fusion in the rack with a mechanical load that is evenly distributed and not excessive.

Circuit overloading
Ensure that no overloading of the circuits occurs which might affect overcurrent protection and supply wiring. The ratings are provided on the unit.

Earthing
Ensure that the rack-mounted equipment is earthed reliably. Consider using supply connections other than direct connections to the branch circuit (e.g. use of power strips).

Power
Check that your ExaLINK Fusion is rated to be used with the mains power in your country.
Total ExaLINK Fusion ratings:
  • 90-264V AC @ 3A max, 50/60 Hz; or
  • 40-72V DC @ 6.7A max
Before servicing
Disconnect the two power supply cables before servicing.
Power cables
Ensure the ExaLINK Fusion uses mains power cables approved in the country of operation
Clock battery
CAUTION: The ExaLINK Fusion has a battery-powered real-time clock circuit. There is a danger of explosion if the battery is replaced incorrectly.
Replace only with CR2032 type coin cells.
Discard used batteries according to the manufacturer's instructions.
Laser safety
CAUTION: SFP+ module used in the ExaLINK Fusion can be a CLASS 1 LASER PRODUCT. Invisible laser radiation may be emitted from the aperture of an SFP+ module when the fiber cables are disconnected.
Do not stare into the open aperture of an SFP+ module and avoid exposure to laser radiation when a fiber cable is disconnected from an SFP+ module.
Warranty void if opened
Do not open the case of the ExaLINK Fusion
The warranty of the ExaLINK Fusion will be void if the case is opened.
An internal tamper switch logs the time and date of events when the lid is removed.
FCC Compliance
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense

This page was last updated on Nov-01-2016.